Every furnace call starts with a combustion and carbon monoxide safety check, not just a symptom fix.
Heat exchanger cracks, ignitor failures, and gas valve issues all fall within our scope.
Furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other hvac repairs don't, so the diagnostic has to start there, which is exactly why furnace repair calls in West, TX get treated with urgency, not a next-available-Tuesday slot.

Most furnace repair problems give some warning before they turn into a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air — catching it early usually means a shorter, cheaper fix.
AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
We're licensed, insured, and staffed with techs who've spent years specifically on furnace repair, not general handyman work with an HVAC certificate bolted on.

Every furnace visit includes a combustion analysis and carbon monoxide test before any repair recommendation.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
Diagnosis happens first, and the quoted flat rate reflects the actual confirmed fault.
No-heat calls during freeze warnings get moved to the front of the schedule.
From the first symptom to the final fix, these are the specific furnace repair services our West-area crews are equipped for.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. Techs handling ignitor & pilot light repair carry the specific parts and tools this job calls for, not a generic kit.
Faulty gas valves are treated as a safety-critical repair, prioritized accordingly. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
We use a combustion analyzer and visual borescope inspection, not guesswork. This is one of the most requested furnace repair calls we get across West, TX.
We test motor amp draw against rated spec before replacement. This is one of the most requested furnace repair calls we get across West, TX.
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Flat-rate quote follows the confirmed fault, before repair begins.
Heat exchanger findings are documented clearly regardless of outcome.

Furnace kept clicking like it wanted to light and never catching.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Thermocouple was the culprit, replaced and tested before the tech left.

Usually a failing ignitor or a fouled flame sensor — both are testable with the right equipment rather than replaced blind.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Electric resistance furnaces fail differently than gas units, and we diagnose accordingly.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
Call dispatch for a live arrival estimate based on current demand.

Whether you're in the heart of West or one of the surrounding communities, dispatch routes the closest available technician.
☎ Call +1-866-805-8548 for West Service